INTRODUCTION
Urea is the major end product of protein nitrogen metabolism. It is synthesized in the liver from ammonia which is produced by amino acid domination. The determination of serum urea nitrogen is an important index of kidney function. Impaired renal function or increased tissue protein breakdown are associated with increased urea nitrogen levels whereas liver damage or pregnancy are associated with decreased levels. (l)

In 1965 Talke and Schubert introduced a procedure utilizing urease and glutamate dehydrogenates (GD). (2) Teco Diagnostics BUN
(UV-ENDPOINT) reagent was developed based essentially on the procedure of Talke and Schubert.

PRINCIPLE
The enzymatic reaction sequence employed in the assay of BUN is as follows:

Urea + H20 Urease > 2NH3 + CO2

NH3 + 2-Oxoglutarate + NADH

+ H+ GD > L-Glutamate + NAD+ + H20

Urea in the sample is hydrolyzed by urease to produce ammonia and carbon dioxide. The liberated ammonia reacts with 2-oxoglutarate in the presence of GD and the coenzyme NADH to produce L-glutamate. In this reaction 2 moles of NADH are oxidized to NAD for each mole of urea hydrolyzed. The resulting decrease in absorbance of NADH at 340 nm is proportional to the level of urea nitrogen in the sample.

REAGENT COMPOSITION
When reconstituted as directed our reagent for BUN contains the
following:

1. (Concentrations refer to the reconstituted reagent )
NADH 0.28 mM/L Urease 3 000 U/L Glutamate Dehydrogenase 15 000 U/L 2-Oxoglutarate 4.0 mM/L Buffer pH 7.8 Activators and non-reactive stabilizers.
2. Urea Nitrogen Standard (20 mg/dl).

WARNINGS AND PRECAUTIONS
1. For in vitro diagnostic use.
2. Avoid ingestion of reagent as toxicity has not yet been determined.
3. Serum specimens should be considered infectious and handled appropriately.
4. Use distilled or deionized water where indicated.

STORAGE AND STABILITY
Both the BUN reagent and Standard must be stored at 2 - 8° C prior to reconstitution. The reagent may be used until the expiration date indicated on the package label. After reconstitution the reagent is stable for two (2) days at room temperature (18 - 25° C) and for fourteen (14) days when stored at 2 - 8° C. The reagent should be clear and colorless.

REAGENT DETERIORATION
The reagent should be discarded if:
1. Turbidity has occurred; turbidity may be a sign of contamination.
2. Moisture has penetrated the vial and caking has occurred.
3. The reconstituted reagent has a reagent blank absorbance less than 1.0 at 340 nm.

SPECIMEN COLLECTION
1. Test specimens should be serum and free from hemolysis.
2. Plasma containing anticoagulants should not be used.
3. All material coming in contact with the sample must be free of ammonia and heavy metals. (4)
4. Urea in serum is reported stable for seventy-two (72) hours
refrigerated at 2 - 8° C. Unrefrigerated serum should be used within eight (8) hours.

INTERFERING SUBSTANCES
Anticoagulants such as fluoride citrate and EDTA may inhibit urease and should be avoided. Ammonium ions present in water or other substances may falsely elevate urea values. Young et al. give a comprehensive review of drug interferences. (5)

MATERIALS REQUIRED BUT NOT PROVIDED
1. Pipettes to accurately measure required volumes.
2. Test tubes/rack.
3. Timer.
4. Distilled or deionized water where Indicated.
5. Spectrophotometer with a temperature controlled cuvette.

GENERAL INSTRUCTIONS
The reagent for BUN is intended for use either as an automated procedure on chemistry instruments or as a manual procedure on a suitable spectrophotometer.

PROCEDURE (AUTOMATED)
Refer to appropriate application manual available from us.

PROCEDURE (MANUAL)
1. Prepare the BUN (UV-ENDPOINT) reagent according to the instructions.
2. Set the spectrophotometer wavelength to 340 nm and asorbance reading to zero with water as reference.
3. Label two cuvets one for reagent blank and the other for
sample.
4. Pipet 1.0 ml BUN (UV-ENDPOINT) reagent into each tube and
warm to assay temperature (37°C 30°C or abient temperature).
5. Add 0.005 mL ( 5 ul ) deionized water and sample (Sample to
reagent ratio 1:200 ) into the corresponding cuvets. Quickly
mix by gentle inversion and incubate for 5 minutes.
6. Read and record asorbance at 340 nm.
* USE TC - MUTI PURPOSE CALIBRATOR TO
REPLACE STANDARD.
NOTE: Following completion of reaction the asorbance (A) remain constant for 30 minutes.

If the spectrophotometer being used requires a final volume greater than l.0 ml for accurate reading use 0.01 m1 (10µ1) of sample to 3.0 ml of reagent Perform the test as described above.

PROCEDURAL LIMITATIONS
The reagent is linear to 60 mg/dl urea nitrogen. Samples with values above 60 mg/dl should be diluted 1:1 with 0.9% saline reassayed and the results multiplied by 2.

CALCULATIONS

Abs of.Blank - Abs of unknown X Concentration = BUN (mg/dl)
Abs of.Blank - Abs of.standard of Standard

Example :
If the unknown blank has an A = 1.368 the standard A =
1.264 the unknown A = 1.317 and the concentration of
standard = 20 mg/dl then:

1.368 - 1.317 X 20 = 9.8 mg/dl
1.368 - 1.264
SI UNITS:
mg/dl x 10 = mg/dl x 0.357
28
Where 10 = Conversion of dl to liter
28 = molecular weight of nitrogen
Example: If 9.8 mg/dl is the result then 9.8 x 0.357 = 3.5 mMol/L.

QUALITY CONTROL
It is recommended that controls be included in each set of assays. Commercially available control material with established BUN values may be used for quality control. The assigned value of the control material must be confirmed by the chosen application. Failure to obtain the proper range of values in the assay of control material may indicate either reagent deterioration instrument malfunction or procedural errors.

EXPECT VALUES
7-18 mg/dl (4)
It is strongly recommended that each laboratory establish its own normal range.

PERFORMANCE CHARACTERISTICS
1. Linearity: 60 mg/dl.
2. Comparison: A comparison using enzymatic procedure yielded a correlation coefficient of 0.96 with a regression equation of y - 0.95x + 3.67.
3. Precision studies:

Within Run
Mean (mg/dl) S.D. C.V.
12 0.5 4.6%
43 0.4 1.0%

Run to Run
Mean (mg/dl) S.D. C.V.
12 0.5 4.6%
43 1.6 3.8%

REFERENCES
1. Henry J.B. Todd Sanford Davidsohn: Clinical Diagnosis and Management by Laboratory Methods 16th ed. W.B. Saunders and Co. Philadelphia PA. p260 (1974).
2. Talke H. Schubert G.E.: Klin. Wchenschr 43:174 (1965).
3. Tiffany T. 0. Jansen J.M. Burtis C.A. Overton J.B. and Scott. C.D.: Clin. Chem. 18:829 (1972).
4. Tietz N.W.: Fundamentals of Clinical Chemistry Philadelphia W.B. Saunders and Co. Philadelphia PA. p 991 (1976).
5. Young D.S. et. al: "Effects of Drugs on Clinical Lab. Tests." Clin. Chem. 18 ID-432D (1972).